NanoPi NEO v140 ignores ssh setting

Having issues with your DietPi installation, or, found a bug? Post it here.
Post Reply
schojo
Posts: 9
Joined: Mon Jan 30, 2017 12:03 pm

NanoPi NEO v140 ignores ssh setting

Post by schojo »

hey,

#DietPi-Software Choice System
#SSH Server Selection:
# 0=none
# -1=dropbear
# -2=opensshserver
AUTO_DietpiSoftware_SSHServerIndex=-2

BUT:

root@XXX:/DietPi# ps -ax|grep drop*
614 ? Ss 0:00 /usr/sbin/dropbear -d /etc/dropbear/dropbear_dss_host_key -r /etc/dropbear/dropbear_rsa_host_key -p 22 -W 65536
2141 ? Rs 0:01 /usr/sbin/dropbear -d /etc/dropbear/dropbear_dss_host_key -r /etc/dropbear/dropbear_rsa_host_key -p 22 -W 65536
5511 pts/0 S+ 0:00 grep drop*
schojo
Posts: 9
Joined: Mon Jan 30, 2017 12:03 pm

Re: NanoPi NEO v140 ignores ssh setting

Post by schojo »

nevermind, it just needed 4 reboot cycles for that ;)
User avatar
Fourdee
Site Admin
Posts: 2782
Joined: Tue Feb 06, 2007 1:36 pm

Re: NanoPi NEO v140 ignores ssh setting

Post by Fourdee »

schojo wrote:4 reboot cycles for that ;)
1 = partition resize
2 = filesystem expansion and update of DietPi
3 = software installation and completion of 1st run setup

You may be interested in AUTO_Install_Enable=1. This will enable automated installation, without the need for logging into the system after each reboot.
If you find our project or support useful, then we’d really appreciate it if you’d consider contributing to the project however you can.
Donating is the easiest – you can use PayPal or become a DietPi patron.
schojo
Posts: 9
Joined: Mon Jan 30, 2017 12:03 pm

Re: NanoPi NEO v140 ignores ssh setting

Post by schojo »

Fourdee wrote:
schojo wrote:4 reboot cycles for that ;)
1 = partition resize
2 = filesystem expansion and update of DietPi
3 = software installation and completion of 1st run setup

You may be interested in AUTO_Install_Enable=1. This will enable automated installation, without the need for logging into the system after each reboot.
it was set to autoinstall, it just took a very long time until it hit the fourth boot cycle, that was a bit weird. but in the end everything was cool, so there we go :)
User avatar
Fourdee
Site Admin
Posts: 2782
Joined: Tue Feb 06, 2007 1:36 pm

Re: NanoPi NEO v140 ignores ssh setting

Post by Fourdee »

schojo wrote: it just took a very long time until it hit the fourth boot cycle, that was a bit weird
Ah yes,

It can do, really depends on what needs patching during the DietPi update. Apt installations can be slow depending on SD card performance.

You can check status of automated installation by logging into the system over SSH, DietPi will give you a message that dietpi-software is already running, this means system is still being setup and next reboot should be completed (if this is stage 3, else, you'll get same message).
If you find our project or support useful, then we’d really appreciate it if you’d consider contributing to the project however you can.
Donating is the easiest – you can use PayPal or become a DietPi patron.
Post Reply