I have the rpi cam running and I can access it at http://camip/rpicam. I am now trying to access it via http://camip:6642/0/config/list but I am unable to. I have to following configured in /etc/motion/motion.conf
But I am still unable to bring up the page.
Also, I am quite familiar with motion pi. In motion pi I was able to start and stop motion with an http get as follows:
http://camip:8080/0/detection/start or http://camip:8080/0/detection/pause
Is it possible to do something similar with rpi cam?
Have some feedback, questions, suggestions, or just fancy a chat? Pop it in here.
1 post • Page 1 of 1