I’m trying to install Node-red on three of Dietpi’s distributions. What’s going on? Please help. @MichaIng [image] [image]

pls do apt install libatomic1 and try again.

This is with 64-bit userland? dpkg --print-architecture We install that library on 32-bit ARM systems automatically, but so far it was not required, or maybe pre-installed, on 64-bit systems :thinking:.

I can replicate it on RPi5, so yes now required on 64bit as well

Also required for x86_64 now, or it was just a dependency : DietPi-Software test · MichaIng/DietPi@9c5687d · GitHub Funnily, on ARMv6 since Bookworm, it is not actually required anymore, since libssl3 depends on it anyway. I’ll fix this for next release.

Fixed with: dietpi-software: Node.js: fix for 64-bit · MichaIng/DietPi@3586912 · GitHub Test installs rerun: DietPi-Software test · MichaIng/DietPi@9c5687d · GitHub

I just installed Dietpi Bullseye on RPI Zero 2W. After Joulinar’s solution (apt install libatomic1) Node-red works fine. I wonder how long these libraries (node-red-node-pi-gpio) will be supported? How do I support my RPI? How do I install Bookworm or Trixie since they don’t support this whole thin…

I had the same problem and solved with Joulinar tip. HP T630 thin client with PC 64bit iso DietPi 9.18.1 Thanks !

DietPi Community Forum

Cannot install Node-red on Dietpi/Bullseye/Bookworm/Trixie

General Discussion

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled