Troubel w/ initial DietPi install (Tinker & Rasp)

[Joulinar]

First of all these are DietPi-Automation settings, applied on first boot of DietPi only, ONCE!

So you would need to set correct values right after flashing your SD card by editing dietpi.txt on your desktop computer where you flashed the SD card before booting first time

I see you have set STATIC IP address

Code: Select all

AUTO_SETUP_NET_USESTATIC=1

This means the following section is describing the IP address of DietPi within your home network

Code: Select all

AUTO_SETUP_NET_STATIC_IP=192.168.0.100
AUTO_SETUP_NET_STATIC_MASK=255.255.255.0
AUTO_SETUP_NET_STATIC_GATEWAY=192.168.0.1

These values you would need to adjust to fit to your local network. As far as I can see, your local network is running at 192.168.200.xxx. That means you would need to adjust as follow.

Code: Select all

# Enter your Static Network details below, if applicable.
AUTO_SETUP_NET_USESTATIC=1
AUTO_SETUP_NET_STATIC_IP=192.168.200.xxx          <------ (pls set a free IP from your network replacing xxx)
AUTO_SETUP_NET_STATIC_MASK=255.255.255.0
AUTO_SETUP_NET_STATIC_GATEWAY=192.168.200.1
AUTO_SETUP_NET_STATIC_DNS=192.168.200.1

Or you can set your system to DHCP. Means your DietPi system will get an IP address assigned from your internet router (if he has DHCP Server function active). This way you could avoid manuell configuration issues. Btw, using DHCP should be default value and would be recommanded on your case.

Code: Select all

# Enter your Static Network details below, if applicable.
AUTO_SETUP_NET_USESTATIC=0

Anyway, easiest way is to flash your SD card with a new image and just boot it up simply without adjusting any network details. Usually you should get an IP address assigned from your internet router.