I want to compile a custom kernel with overlayfs support for ASUS Tinker Board but it simply would not boot. I installed DietPI and am trying to replace its kernel.
The kernel I am using:
The commands I use to compile kernel:
After I do that I get zImage and device tree, I mount the boot partition of SD card and copy zImage and device tree there. When I give the board power it starts off with the red light on (which should be ok), then the red light stops and the green one has a short blink and only darkness after.
Code: Select all
make rockchip_linux_defconfig # Here I enable Overlayfs support, I also disable networking support because otherwise it does not compile make menuconfig make -j8 zImage modules rk3288-miniarm.dtb
What could I be doing wrong? How does u-boot load the kernel on ASUS Tinker Board?