# Docs: https://www.raspberrypi.org/documentation/configuration/config-txt/

#-------Display---------
# If you get no picture, set the following to "1" to apply most compatible HDMI settings.
#hdmi_safe=1

# Uncomment to adjust the HDMI signal strength if you have interferences, blanking, or no display.
# - Values from "0" to "11" are allowed, use values above "7" only if required, e.g. with very long
# - Default on first RPi1 A/B is "2", else "5", on RPi4 this setting is ignored.
#config_hdmi_boost=5

# Uncomment if HDMI display is not detected and composite is being outputted.
#hdmi_force_hotplug=1

# Uncomment to disable HDMI even if plugged, e.g. to force composite output.
#hdmi_ignore_hotplug=1
 hdmi_ignore_cec=1

# Uncomment to force a console size. By default it will be display's size minus overscan.
#framebuffer_width=1280
#framebuffer_height=720

# Uncomment to enable SDTV/composite output on RPi4. This has no effect on previous RPi models.
#enable_tvout=1
# SDTV mode
#sdtv_mode=0

# Uncomment to force a specific HDMI mode (this will force VGA).
#hdmi_group=1
#hdmi_mode=1

# Uncomment to force an HDMI mode rather than DVI. This can make audio work in DMT (computer monito
#hdmi_drive=2

# Set "hdmi_blanking=1" to allow the display going into standby after 10 minutes without input.
# With default value "0", the display shows a blank screen instead, but will not go into standby.
# NB: With "1" some applications (e.g. Kodi, OMXPlayer) cannot prevent display standby due to missi
#hdmi_blanking=1

# Set to "1" if your display has a black border of unused pixels visible.
disable_overscan=1

# Uncomment the following to adjust overscan. Use positive numbers if console goes off screen, and 
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# Rotation
display_hdmi_rotate=0
lcd_rotate=0

#-------RPi camera module-------
start_x=1
#disable_camera_led=1

#-------GPU memory splits-------
gpu_mem_256=96
gpu_mem_512=96
gpu_mem_1024=96

#-------Boot splash screen------
disable_splash=1

#-------Onboard sound----------
dtparam=audio=on

#-------I2C-------------
dtparam=i2c_arm=on
#dtparam=i2c_arm_baudrate=100000

#-------SPI-------------
dtparam=spi=off

#-------Serial/UART-----
# NB: Enabled for 1st run only. If you want to keep this setting, please set CONFIG_SERIAL_CONSOLE_
#core_freq=500
enable_uart=0

#-------Overclock-------
temp_limit=75
initial_turbo=20

#over_voltage=0
#arm_freq=1500
#core_freq=500

#over_voltage_min=0
#arm_freq_min=300
#core_freq_min=250
#sdram_freq_min=400
arm_64bit=1
dtoverlay=disable-wifi
dtoverlay=rpivid-v4l2