# Wyze Webcam Rock64 Octoprint **URL:** https://dietpi.com/forum/t/wyze-webcam-rock64-octoprint/16426 **Category:** Troubleshooting **Created:** [29 March 2023 11:32 UTC](https://dietpi.com/forum/t/wyze-webcam-rock64-octoprint/16426 "2023-03-29T11:32:32Z") **Posts on this page:** 1 **Page:** 1
### Author: ![iamwally](https://dietpi.com/forum/user_avatar/dietpi.com/iamwally/32/3810_2.png) [@iamwally](https://dietpi.com/forum/u/iamwally) #### Post date: [29 March 2023 11:32 UTC](https://dietpi.com/forum/t/wyze-webcam-rock64-octoprint/16426/1 "2023-03-29T11:32:33Z")
Hi folks! New to dietpi so bear with me. Was using a raspberry pi3b+ with octopi for my 3d printers. Since pi’s are in short supply and I need to recover them to use for something else I decided to replace them with Rock64’s and dietpi with octoprint. Everything went well with the switchover except the webcam to monitor my printing through octoprint. I had been using a wyze cam v2 running the webcam firmware and it worked flawlessly with the pi3b+ and octopi. Dietpi on the Rock64 won’t even acknowledge that it is connected. When I run lsusb it does not see anything for the webcam. I have tried a different webcam and it does come up when I run lsusb and I have been able to get it to work with mjpg-streamer no problem. So I guess I am asking any ideas what would be causing that wyze webcam to not show up? Would it be a driver issue of some kind? I know the simple answer is to use a different webcam but I have mounts made for the wyze already attached and setup on the 3d printers already so I would really like to use them. Thank you, John ### Creating a bug report/issue #### Required Information - DietPi version | `cat /boot/dietpi/.version` - Distro version | `echo $G_DISTRO_NAME $G_RASPBIAN` - Kernel version | `uname -a` - SBC model | `echo $G_HW_MODEL_NAME` or (EG: RPi3) - Power supply used | (EG: 5V 1A RAVpower) - SD card used | (EG: SanDisk ultra) #### Additional Information (if applicable) - Software title | (EG: Nextcloud) - Was the software title installed freshly or updated/migrated? - Can this issue be replicated on a fresh installation of DietPi? ← If you sent a “dietpi-bugreport”, please paste the ID here → - Bug report ID | `echo $G_HW_UUID` #### Steps to reproduce 1. … 2. … #### Expected behaviour - … #### Actual behaviour - … #### Extra details - …