Install using console only

Is there a way, configuration, setting, that will allow my to do the full installation using the console only?
Using the console, the output stops at
[ 3.735576] udevd[174]: starting version 175
[ 5.651328] EXT4-fs (mmcblk0p2): re-mounted. Opts: (null)
[ 5.891395] EXT4-fs (mmcblk0p2): re-mounted. Opts: (null)

Thanks

I’am not exactly sure what your request is. Please could you provide better information?

If your question is to setup DietPi without using the whiptail menus, its not possible at the moment.

I guess that would be the answer.
I don’t have access to a monitor at this and I was trying use diet pi instead of raspbian.

Has ipv6 been added to the networking menus?

Thanks

You can still use and setup DietPi remotely using a SSH connection.

Dropbear is installed by default. Here are the details to connect:
http://dietpi.com/phpbb/viewtopic.php?f=8&t=5&start=10#p62

You can use our pre-setup Kitty SSH client, all you will need to do is change the IP address to your RPi’s address:
http://goo.gl/CuCAhe

IPv6 is currently disabled in all DietPi images to reduce resources. I’ve created a ticket for your request:
https://github.com/Fourdee/DietPi/issues/72

Thanks @Fourdee :slight_smile: